Mitchell Standard

After winning last week’s struggle with the rear bearing race, I could actually move on to properly aligning the shutter in the camera casting. I hope you will all forgive the tedious details of this process, but it seemed important to me to outline the many steps it took to achieve this. Several things had […]

First off, I want to thank everyone for all of the wonderful suggestions they made. All of them were quite good and helpful. Before I had read your suggestions however, I went at this problem with a thread file, honing stones, and lapping compound. After several hours of work, I was able to get the

Why is it that the jobs that are supposed to be the simplest always turn out to be the most complicated? Thinking that the most labor-intensive part of the restoration of Mitchell 46 was behind me now, I was supposed to be at the point where I reassemble the working components of the camera, set

I thought everyone might appreciate a short video of Mitchell Standard #46 racking over for the first time in decades. This 6 seconds of video represents 5 months of hard work that has finally paid off.

True to my word, I struggled through the myriad of steps needed to get Mitchell 46 back onto its rackover L-base this week. On its surface, this sounds like a simple process, but without the various fixtures that the Mitchell factory had to complete this, the process becomes complicated. Mechanically, the rackover L-base is a

Somehow we find ourselves in July already (not sure how that happened!), so we decided to take a couple of days off for the 4th of July holiday and relax. Now though, we are back to work on Mitchell 46, along with the dozen other projects we have going at the same time. Much to

As there has been nothing simple about bringing Mitchell 46 back to life, it is only fitting that the process of getting the camera securely mounted to the milling machine, and true and parallel to the film plane, was a week-long endeavor. This process had to take into consideration machining the bottom surface of the

With my work on the Dykstraflex camera complete, I have returned my attention to Mitchell 46. I dusted off the setup on the mill, re-indicated all the surfaces that needed to be true, and began to make a tool path map. I had transferred the actual position of the camera movement to the aluminum plate

Despite my good intentions, replacing the roof on our building interfered tremendously with progress on Mitchell 46 this week. My next step in restoring this camera was to prepare the casting so it can be accurately mounted on the milling machine. There are very few things on the casting that remain true, so the only